Cisco ONS 15454 - NTP-G12 Install and Close the FMEC Cover (ETSI Only)

Figure 58: Alarm Output Connector
Step 4 Continue with the NTP-G13 Install the Rear Cover (ANSI Only), on page 118 as needed.
Stop. You have completed this procedure.
NTP-G12 Install and Close the FMEC Cover (ETSI Only)
This procedure installs and closes the ONS 15454 ETSI FMEC cover.Purpose
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Tools/Equipment
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), on page 60Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Cisco ONS 15454 Hardware Installation Guide
117
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G12 Install and Close the FMEC Cover (ETSI Only)