Cisco ONS 15454 - NTP-G304 Configure the MS-ISC-100 T Card for a ONS 15454 Multishelf Node for Non-Default Public and Private VLAN Ids

Stop. You have completed this procedure.
NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454
Multishelf Node for Non-Default Public and Private VLAN IDs
Use this procedure to configure the MS-ISC-100T Card for a multi-shelf node
for non-default public and private VLAN IDs.
Purpose
VoltmeterTools/Equipment
Applicable procedures in Installing the ONS 15454 M12 (ANSI and ETSI) Shelf,
on page 23
Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1 At the Cisco IOS command line interface (CLI) for the MS-ISC-100T card, enter the following spanning tree
commands:
Example:
Router(config)# bridge public VLAN ID protocol rstp
Router(config)# bridge public VLAN ID forward-time 5
Router(config)# bridge public VLAN ID max-age 10
Router(config)# bridge private VLAN ID protocol rstp
Router(config)# bridge private VLAN ID forward-time 5
Router(config)# bridge private VLAN ID max-age 10
Step 2 Enter the following commands to configure the ports DCN 1 and DCN 2:
Example:
(Router(config)# interface FastEthernet0
(Router(config-if)# no ip address
(Router(config-if)# no ip route-cache
(Router(config-if)# bridge-group public VLAN ID
(Router(config)# interface FastEthernet1
(Router(config-if)# no ip address
(Router(config-if)# no ip route-cache
(Router(config-if)# bridge-group public VLAN ID
Cisco ONS 15454 Hardware Installation Guide
141
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454 Multishelf Node for Non-Default Public and Private VLAN IDs