EasyManua.ls Logo

Cisco ONS 15454 - Page 172

Cisco ONS 15454
516 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Step 3 Enter the following commands to configure ports SSC 1 through SSC 7. Replace port with the port number
(2 to 8) and repeat for each port.
Example:
(Router(config)#interface FastEthernet port
(Router(config-if)# no ip address
(Router(config-if)# no ip route-cache
(Router(config-if)# bridge-group private VLAN ID
Step 4 Enter the following commands to configure port NC (port 9):
Example:
Router(config)# interface FastEthernet9
Router(config-if) no ip address
(Router(config-if) no ip route-cache
Router(config)# interface FastEthernet9.2
(Router(config-if)dot1Q public VLAN ID native
(Router(config-if) no ip route-cache
(Router(config-if) no snmp trap link-status
(Router(config-if)bridge-group public VLAN ID
Router(config)# interface FastEthernet9.2
(Router(config-if) encapsulation dot1Q private VLAN ID
(Router(config-if) no ip route-cache
(Router(config-if) no snmp trap link-status
(Router(config-if)bridge-group private VLAN ID
Step 5 Enter the following commands to configure port PRT (port 10):
Example:
Router(config)# interface FastEthernet10
(Router(config-if)# no ip address
(Router(config-if)# no ip route-cache
Router(config)# interface FastEthernet10.1
(Router(config-if)encapsulation dot1Q public VLAN ID native
(Router(config-if)# no ip route-cache
(Router(config-if)# no snmp trap link-status
(Router(config-if)bridge-group public VLAN ID
(Router(config-if)# bridge-group public VLAN ID priority 0
!
Router(config)# interface FastEthernet10.2
(Router(config-if)encapsulation dot1Q private VLAN ID
(Router(config-if)# no ip route-cache
(Router(config-if)# no snmp trap link-status
(Router(config-if)# bridge-group private VLAN ID
(Router(config-if)# bridge-group private VLAN ID priority 0
Router(config)# interface FastEthernet11
Router(config)# no ip address
Router(config)# no ip route-cache
Router(config)# shutdown
Cisco ONS 15454 Hardware Installation Guide
142
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454 Multishelf Node for Non-Default Public and Private VLAN IDs

Table of Contents

Other manuals for Cisco ONS 15454

Related product manuals