Procedure
Step 1 Insert the cover carefully onto the left pin of the hinge as shown in the following figure.
Step 2 Move the cover to the right side towards the right pin of the hinge.
Step 3 Pull the right side of the hinge-locking spring. Push the cover onto the right pin until the spring snaps into
place.
Figure 59: ONS 15454 ETSI FMEC Cover
Step 4 Attach the ground wire to the shelf.
Step 5 Attach the washer and nut.
Step 6 Attach the cover to the shelf using the screws on the top of the cover.
Step 7 Continue with the NTP-G14 Install DWDM Equipment, on page 123.
Stop. You have completed this procedure.
NTP-G13 Install the Rear Cover (ANSI Only)
The following procedure explains how to install the rear cover on an ONS 15454
ANSI shelf.
Purpose
Cisco ONS 15454 Hardware Installation Guide
118
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G13 Install the Rear Cover (ANSI Only)
To Next Page
Loading...
