During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Warning
Always use the supplied ESD wristband when working with a powered ONS 15454 M2 and ONS 15454 M6
shelf assemblies. For detailed instructions on how to wear the ESD wristband, refer to the Electrostatic
Discharge and Grounding Guide for Cisco CPT and Cisco ONS Platforms.
Caution
If you install a card incorrectly, the FAIL LED flashes continuously.
Note
Procedure
Step 1 Complete the DLP-G604 Install the TNC, TNCE, TSC, or TSCE Card, on page 262.
If you install the wrong card in a slot, see the NTP-G107 Remove Permanently or Remove and
Replace DWDM Cards .
Note
Step 2 Complete the DLP-G605 Provision PPM and Port for the TNC and TNCE Cards, on page 265.
Step 3 Complete the DLP-G606 Configure UDC and VoIP for the TNC and TNCE Cards, on page 266.
Stop. You have completed this procedure.
DLP-G604 Install the TNC, TNCE, TSC, or TSCE Card
(ONS 15454 M2 and ONS 15454 M6 only) This task installs redundant
TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O cards on the ONS 15454 M6 shelf
and a stand-alone TNC/TNCE/TSC/TSCE/TNCs-2/TNCS-2O card on the ONS
15454 M2 shelf. Install and initialize the
TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O card before installing any other line
cards into the shelf assemblies. On the ONS 15454 M6 shelf, install the
TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O cards in slots 1 and 8 for redundancy.
On the ONS 15454 M2 shelf, install the stand-alone
TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O card in slot 1.
Purpose
Two TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O cards for the ONS 15454 M6
shelf and one TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O card for the ONS 15454
M2 shelf
Tools/Equipment
NonePrerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
Cisco ONS 15454 Hardware Installation Guide
262
Installing the ONS 15454 M2 Shelf
DLP-G604 Install the TNC, TNCE, TSC, or TSCE Card
To Next Page
Loading...
