Cisco ONS 15454 - NTP-G270 Open and Remove the Standard Door of the ONS 15454 M2 Shelf

Step 5 Tighten the door screws to a torque value of 6.5 in-lb (0.75 N-m) to close the standard door as shown in the
following figure.
Figure 138: Close the Standard Door of ONS 15454 M2 Shelf
Stop. You have completed this procedure.
NTP-G270 Open and Remove the Standard Door of the ONS 15454 M2 Shelf
This procedure opens and removes the standard door of the ONS 15454 M2.Purpose
#2 Phillips Dynamometric screwdriverTools/Equipment
• NTP-G266 Install the ONS 15454 M2 Shelf, on page 194.
• NTP-G269 Install the Standard Door of the ONS 15454 M2 Shelf, on page
216.
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, refer to the Electrostatic Discharge and Grounding
Guide for Cisco CPT and Cisco ONS Platforms.
Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1 Complete the DLP-G594 Open the Standard Door of the ONS 15454 M2 Shelf, on page 219.
Step 2 Complete the DLP-G595 Remove the Standard Door of the ONS 15454 M2 Shelf, on page 220.
Cisco ONS 15454 Hardware Installation Guide
218
Installing the ONS 15454 M2 Shelf
NTP-G270 Open and Remove the Standard Door of the ONS 15454 M2 Shelf