If protective clips are installed on the backplane connectors of the cards, remove the clips before installing
the cards.
Note
If you install a card incorrectly, the FAIL LED flashes continuously.
Note
Procedure
Step 1 (Cisco ONS 15454 only) Complete the DLP-G33 Install the TCC2, TCC2P, or TCC3 Card , on page 132.
If you install the wrong card in a slot, see the NTP-G107 Remove Permanently or Remove and
Replace DWDM Cards procedure.
Note
Step 2 (Cisco ONS 15454 only) Complete the DLP-G34 Install the AIC-I Card, on page 135, if necessary.
Step 3 (Cisco ONS 15454 only) Complete the DLP-G309 Install the MS-ISC-100T Card , on page 136, if necessary.
Stop. You have completed this procedure.
DLP-G33 Install the TCC2, TCC2P, or TCC3 Card
This task installs redundant TCC2/TCC2P/TCC3 cards. The first card you install
in the ONS 15454 must be a TCC2/TCC2P/TCC3 card, and it must initialize
before you install any cross-connect or traffic cards. Cross-connect cards are only
required in hybrid nodes.
Purpose
Two TCC2/TCC2P/TCC3 cardsTools/Equipment
NonePrerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Do not remove a TCC2/TCC2P/TCC3 card during the software transfer process, which is indicated by alternate
flashing FAIL and ACT/STBY LEDs. Removing a TCC2/TCC2P/TCC3 during the software transfer process
will corrupt the system memory.
Caution
Allow each card to boot completely before installing the next card.
Note
Cisco ONS 15454 Hardware Installation Guide
132
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G33 Install the TCC2, TCC2P, or TCC3 Card
To Next Page
Loading...
