Step 6 In the Pluggable Ports area, click Create. The Create Port dialog box appears.
Step 7 In the Create Ports dialog box, complete the following:
• Port—Choose the port you want to configure from the Port drop-down list.
• Port Type—Choose the port type, such as OC-3, FE, or ONE-GE from the Port Type drop-down list.
OC-3 can be configured only on PPM port 1. FE and ONE-GE can be configured on both the ports.
Note
Step 8 Click OK. The newly created port appears in the Pluggable Ports area. The port type you provisioned is listed
in the Rate column.
Step 9 Repeat Steps 3 through 8 to provision another PPM and port on the TNC and TNCE cards.
Step 10 Return to your originating procedure (NTP).
DLP-G606 Configure UDC and VoIP for the TNC and TNCE Cards
(ONS 15454 M2 and ONS 15454 M6 only) This task configures UDC and VoIP
traffic for the TNC and TNCE cards.
Purpose
NoneTools/Equipment
DLP-G46 Log into CTC
NTP-G38 Provisioning OSC Terminations
DLP-G605 Provision PPM and Port for the TNC and TNCE Cards, on page 265
Prerequisite Procedures
As neededRequired/As Needed
Onsite or remoteOnsite/Remote
NoneSecurity Level
Each TNC and TNCE cards support UDC/VoIP configuration. You can configure UDC or VoIP on the two
SFP ports present on the TNC and TNCE cards. The TNC and TNCE cards support the UDC/VoIP configuration
only when OSC is provisioned on the SFP ports.
Note
If two nodes are connected through the fiber and if the TNC and TNCE cards in one node has UDC
configuration, the TNC and TNCE cards in the other node must also have UDC configuration. The same rule
applies to VoIP configuration.
Note
Procedure
Step 1 In node view (single-shelf mode) or shelf view (multishelf view), double-click the TNC and TNCE cards
where you want to configure UDC and VoIP.
Cisco ONS 15454 Hardware Installation Guide
266
Installing the ONS 15454 M2 Shelf
DLP-G606 Configure UDC and VoIP for the TNC and TNCE Cards
To Next Page
Loading...
