Cisco ONS 15454 - DLP-G13 Remove the Lower Backplane Cover

NoneSecurity Level
Procedure
Step 1 Complete the DLP-G13 Remove the Lower Backplane Cover , on page 64.
Step 2 Complete the DLP-G14 Remove the Backplane Sheet Metal Cover , on page 65.
Step 3 Continue with the NTP-G7 Install the Power and Ground , on page 68.
Stop. You have completed this procedure.
DLP-G13 Remove the Lower Backplane Cover
This task removes the lower backplane cover of the ONS 15454 ANSI shelf.Purpose
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Tools/Equipment
NonePrerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1 Unscrew the five retaining screws that hold the cover in place as shown in the following figure.
Figure 38: Lower Backplane Cover
Cisco ONS 15454 Hardware Installation Guide
64
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G13 Remove the Lower Backplane Cover