Cisco ONS 15454 - DLP-G12 Remove the FMEC Cover

Figure 36: Unscrewing the FMEC Cover
Step 2 Use the handles to pull the cover forward.
Step 3 Return to your originating procedure (NTP).
DLP-G12 Remove the FMEC Cover
This task removes the FMEC cover in order to install the MIC-A/P and the
MIC-C/T/P.
Purpose
Medium slot-head screwdriverTools/Equipment
DLP-G11 Open the FMEC Cover , on page 61Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1 Unscrew the nut holding the ground wire to the shelf. Remove the nut and washer.
Step 2 Remove the ground wire from the left side of the shelf.
Cisco ONS 15454 Hardware Installation Guide
62
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G12 Remove the FMEC Cover