Cisco ONS 15454 - DLP-G595 Remove the Standard Door of the ONS 15454 M2 Shelf

Step 3 Swing the door open.
Figure 140: Cisco ONS 15454 M2 Standard Door—Opened
Step 4 Return to your originating procedure (NTP).
DLP-G595 Remove the Standard Door of the ONS 15454 M2 Shelf
This task removes the standard door of the ONS 15454 M2 system.Purpose
#2 Phillips Dynamometric screwdriverTools/Equipment
• DLP-G594 Open the Standard Door of the ONS 15454 M2 Shelf, on page
219.
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, refer to the Electrostatic Discharge and Grounding
Guide for Cisco CPT and Cisco ONS Platforms .
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1 Unscrew the nut holding the ground cable to the shelf. Remove the nut.
Step 2 Remove the ground cable from the shelf as shown in the following figure
Cisco ONS 15454 Hardware Installation Guide
220
Installing the ONS 15454 M2 Shelf
DLP-G595 Remove the Standard Door of the ONS 15454 M2 Shelf