Cisco ONS 15454 - NTP-G331 Remove the Deep-Front Panel of the ONS 15454 M2 Shelf

Figure 149: Connecting the Ground Strap Cable
Stop. You have completed this procedure.
NTP-G331 Remove the Deep-Front Panel of the ONS 15454 M2 Shelf
This procedure removes the deep-front panel of the ONS 15454 M2 system.Purpose
• #2 Phillips Dynamometric screwdriver
• Socket (6/32 standard) and socket wrench to tighten or loosen the ground
nut
Tools/Equipment
• NTP-G266 Install the ONS 15454 M2 Shelf, on page 194
• NTP-G343 Install the Deep-Front Panel of the ONS 15454 M2 Shelf, on
page 222
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, see the Electrostatic Discharge and Grounding Guide
for Cisco CPT and Cisco ONS Platforms .
Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
The deep-front panel does not have a hinge and cannot be rotated like a standard door. Rotating the deep front
panel can damage the deep-front panel, shelf hinges, other devices and cables placed below the ONS 15454
M2 shelf.
Caution
Cisco ONS 15454 Hardware Installation Guide
226
Installing the ONS 15454 M2 Shelf
NTP-G331 Remove the Deep-Front Panel of the ONS 15454 M2 Shelf