Install PP-Mesh on an ETSI Configuration
This procedure describes the steps to install the PP-Mesh on an ETSI configuration:
Procedure
Step 1 Set the mounting brackets to the rack you are using.
Step 2 Install the right and left ETSI bracket to the unit using the four washer and the screws provided with the
installation kit.
Figure 92: Right and Left ETSI Bracket
Step 3 Install the right Mesh Panel unit in the ETSI rack. To ensure safe unit mounting, use at least two screws on
each side.
Figure 93: Mesh Panel Unit in ETSI Rack
Cisco ONS 15454 Hardware Installation Guide
171
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Install PP-Mesh on an ETSI Configuration
To Next Page
Loading...
