Cisco ONS 15454 - Page 144

Table 21: Alarm Input Pin Assignments
Signal NameAMP Champ PinSignal NameAMP Champ Pin
GND27ALARM_IN_1–1
ALARM_IN_2–28GND2
ALARM_IN_4–29ALARM_IN_3–3
GND30ALARM_IN_5–4
ALARM_IN_6–31GND5
ALARM_IN_8–32ALARM_IN_7–6
GND33ALARM_IN_9–7
ALARM_IN_10–34GND8
ALARM_IN_12–35ALARM_IN_11–9
GND36ALARM_IN_13–10
ALARM_IN_14–37GND11
ALARM_IN_16–38ALARM_IN_15–12
GND39ALARM_IN_17–13
ALARM_IN_18–40GND14
ALARM_IN_20–41ALARM_IN_19–15
GND42ALARM_IN_21–16
ALARM_IN_22–43GND17
ALARM_IN_24–44ALARM_IN_23–18
GND45ALARM_IN_25–19
ALARM_IN_26–46GND20
ALARM_IN_28–47ALARM_IN_27–21
GND48ALARM_IN_29–22
ALARM_IN_30–49GND23
—50ALARM_IN_31–24
GND151ALARM_IN_+25
GND252ALARM_IN_0-26
The following table lists the alarm output (external control) pin assignments.
Cisco ONS 15454 Hardware Installation Guide
114
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G11 Install an External Wire-Wrap Panel on the AEP (ANSI Only)