CompletedDescription
NTP-G306 Install the ONS 15454 Shelf, on page 31
NTP-G3 Open and Remove the Front Door , on page 56
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), on page 60
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only), on page 66
NTP-G7 Install the Power and Ground , on page 68
NTP-G8 Install the Fan-Tray Assembly , on page 82
ONS 15454 ANSI Alarm, Timing, LAN, and Craft Pin Connections, on page 94
NTP-G12 Install and Close the FMEC Cover (ETSI Only), on page 117
NTP-G14 Install DWDM Equipment, on page 123
NTP-G15 Install the Common Control Cards, on page 131
NTP-G301 Connect the ONS 15454 Multishelf Node and Subtending Shelves to an MS-ISC-100T
Card, on page 138 or NTP-G295 Connect the ONS 15454 Multishelf Node and Subtending
Shelves to a Catalyst 2950 or Catalyst 3560, on page 146
NTP-G298 Configure a Cisco Catalyst 2950 or Catalyst 3560 (Active and Standby) for a ONS
15454 Multishelf Node, on page 152 (if you completed NTP-G295 Connect the ONS 15454
Multishelf Node and Subtending Shelves to a Catalyst 2950 or Catalyst 3560, on page 146)
Step 2 If you installed an ONS 15454 ANSI shelf, complete the following table by verifying that each applicable
procedure was completed.
Table 25: ONS 15454 ANSI Shelf Installation Task Summary
CompletedDescription
NTP-G305 Unpack and Inspect the ONS 15454, ONS 15454 M2, and ONS 15454 M6 Shelves,
on page 20
NTP-G306 Install the ONS 15454 Shelf, on page 31
NTP-G3 Open and Remove the Front Door , on page 56
NTP-G5 Remove the Backplane Covers (ANSI Only), on page 63
NTP-G7 Install the Power and Ground , on page 68
NTP-G8 Install the Fan-Tray Assembly , on page 82
NTP-G9 Install the Alarm Expansion Panel (ANSI Only), on page 91
ONS 15454 ANSI Alarm, Timing, LAN, and Craft Pin Connections, on page 94
NTP-G11 Install an External Wire-Wrap Panel on the AEP (ANSI Only), on page 112
Cisco ONS 15454 Hardware Installation Guide
144
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G307 Perform the ONS 15454 Shelf Installation Acceptance Test
To Next Page
Loading...
