In order to connect the ONS 15454 M6 subtending shelves to the ONS 15454 M6 node controller
without using a catalyst, follow the steps described in NTP-G308 Connect the ONS 15454 M6
Multishelf Node and the ONS 15454 M6 Subtending Shelves, on page 407. To connect an ONS
15454 subtending shelf to the ONS 15454 M6 node controller without using a catalyst switch,
connect the MSM ports that correspond to the TNC/TNCE/TSC/TSCE cards in Slot 1 and Slot 8
of the ONS 15454 M6 node controller to the ONS 15454 subtending shelf TCC2/TCC2P/TCC3
cards in Slot 7 and Slot 11.
Note
Step 7 Return to your originating procedure (NTP).
DLP-G729 Connect the ONS 15454 M6 as the Node Controller in a Mixed
Multishelf Configuration without a Catalyst Switch
Use this procedure to connect the ONS 15454 M6 as the node controller and a
mix of ONS 15454 and ONS 15454 M6 as subtending shelves without using a
Catalyst switch.
Purpose
• Cross-over (CAT-5) LAN cables (3, plus 2 for each subtending shelf)Tools/Equipment
NTP-G15 Install the Common Control Cards, on page 131.
NTP-G313 Install and Configure the TNC, TNCE, TSC, or TSCE Card, on page
261
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
The MSM (multishelf management) ports are present on the ECU module. The MSM ports located on the left
side of the ECU module correspond to the TNC/TNCE/TSC/TSCE card in Slot 1, and the MSM ports located
on the right side correspond to the TNC/TNCE/TSC/TSCE card in Slot 8. For more information about the
ECU module and MSM ports, see the External Connection Units, on page 342.
Note
Use the craft terminal port or the EMS port present on the ECU module to connect the ONS 15454 M6 node
controller to the LAN.
Note
Procedure
Step 1 To connect an ONS 15454 M6 subtending shelf to the ONS 15454 M6 node controller, complete the following:
a) Using a cross-over (CAT-5) LAN cable:
Cisco ONS 15454 Hardware Installation Guide
413
Installing the ONS 15454 M6 Shelf
DLP-G729 Connect the ONS 15454 M6 as the Node Controller in a Mixed Multishelf Configuration without a Catalyst Switch
To Next Page
Loading...
