CONTACTS
ADDING A CONTACT
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 119
1 Press or to select the HF network that you want to use.
1 Press to move to the Call Type entry.
1 Press or to select the call type that you want to use.
NOTE: The call type that you select affects information
that you can enter for the remainder of this call.
1 If you are adding:
• a Selective, Channel Test, Emergency, Get Position or
Send Position call, continue from
Adding a simple call on
page 119
• a Message call, continue from Adding a Message call on
page 120
• a Phone call, continue from Adding a Phone call on
page 122
Adding a simple call
A simple call requires an address only at this stage of the definition
process.
To continue with adding a Selective, Channel Test, Emergency, Get
Position or Send Position call:
1 Press to move to the Selcall|ALE Address entry.
1 Enter the address of the station that you want to call.
1 Continue from Completing the contact on page 123.
To Next Page
Loading...
