OPERATING THE TRANSCEIVER
CALLING
54 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Figure 9: Chain call
Making a Selective call
If you want to speak with the operator at a particular station, make a
Selective call to the address of that station. When the station receives
the call, the transceiver sounds an alert tone to notify the operator.
To make a Selective call:
1 Press CALL.
NOTE: You may be prompted to register a self address on
this control point for the HF network that you are
using to make the call.
The call type and address of the last call are shown at the top of
the call screen. The filtered Call Log below this shows the latest
instance of any call type made to or received from a particular
address.
countdown to next call
number of calls
completed
total number of calls
set up in the chain call
To Next Page
Loading...
Need help?
General
