OPERATING THE TRANSCEIVER
CALLING
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 61
NOTE: Depending on the setup of the HF network used
for the call and the digital voice and/or encryption
options installed in the transceiver, the transceiver
may switch automatically between
analogue/digital voice and/or clear/secure signals.
1 If you are receiving a Selective or Emergency call, answer the
call by holding PTT and speaking side-on across the microphone
in the handset, or directly into the microphone on the desk
console.
1 If you are receiving a Phone call, press PTT to accept the call,
then release PTT.
An automatic voice message is played that asks you to wait
while the connection is made. Do not speak during this time.
Viewing missed calls
If you do not answer a call on your transceiver, a missed call pop-up is
shown on the channel screen. The icon for the call type is shown with
an exclamation mark. You can scroll through the missed call pop-up to
acknowledge the missed calls. If the missed call pop-up is closed
without acknowledging a missed call, a missed call icon for the call is
shown in the status bar of the channel screen. If the missed call pop-up
contains a short message that may be viewed fully in the pop-up, a
missed call icon is not shown for this message in the status bar when you
close the pop-up.
A list of the possible missed call icons in the status bar is provided in
Table 2. The details of any missed call may be viewed in the pop-up, or
via the Call History or Call Log.
NOTE: The incoming call pop-up changes to a missed call
pop-up when the sending station hangs up the voice-type
call, or when the period set in Settings > Calling >
General > In Call Timeout has lapsed.
To Next Page
Loading...
Need help?
General
