OPERATING THE TRANSCEIVER
SELECTING A CHANNEL
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 37
Selecting a channel
To select a channel:
1 Press PTT to exit to the channel or scanning screen.
1 If the transceiver is scanning, press SCAN to switch off
scanning.
1 Press or to scroll to the channel that you want to use.
The channel is selected.
NOTE: If you want to change the sideband, press MODE.
If the mode does not change, there is only one
mode for the channel.
NOTE: If you have an automatic antenna tuner fitted,
press PTT to tune the antenna to the currently
selected channel.
1 Do any of the following:
• Hold OK to edit the channel, if permitted.
•PressOK to search for a channel.
•PressCALL to start a call.
• Hold CALL to go to Contacts.
To Next Page
Loading...
Need help?
General
