OPERATING THE TRANSCEIVER
THE CHANNEL SCREEN
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 35
Your transceiver may have the option of selecting high, medium, or low
power, as set in Settings > Configuration > Tx Power. By default,
you can toggle between the Tx power settings by pressing the 6 key. Hi,
Med, or Lo is shown respectively to the right of the signal strength
indicator. If an external power amplifier is connected, PA may also be
selected.
While a call is being established, the transceiver shows that calling
activity is in progress by flashing in place of the scan indicator. Once
a call is established, these indicators are replaced with an icon that
represents the type of call being sent or received.
NOTE: For detailed information on call types, please see the
Reference Manual.
Figure 7: System lock and connected data application icons
When the transceiver is scanning, the channel screen is replaced by the
scanning screen.
system lock
icon
connected data
application icon
To Next Page
Loading...
