OPERATING THE TRANSCEIVER
SELECTING A CHANNEL FROM A CHANNEL GROUP
38 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Selecting a channel from a channel
group
If channel grouping is enabled in Settings > Control Point >
Channel Grouping and you have allocated channels to groups,
indicated by ... after a channel group name or in front of the channel
name, you may have to switch to another channel group to find the
channel that you want to select.
NOTE: Any channels that are not assigned to a channel group
appear at the top level with the channel group names.
These channels are selected by scrolling to the channel.
NOTE: You can set the name of the current channel group to
show in a status area of the channel screen.
To select a channel from a channel group:
1 Press PTT to exit to the channel or scanning screen.
1 If the transceiver is scanning, press SCAN to switch off
scanning.
1 If you are at the channel group level, which may include
ungrouped channels, press or to scroll to the channel
group that you want, then press to view the channels within
that group.
Channel level (within a group)
Channel group level
and ungrouped channels
channel group name
To Next Page
Loading...
Need help?
General
