Codan Envoy Control Getting Started Guide

USING THE WIZARD
USING THE WIZARD
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 19
1 Highlight the icon for the wizard ( ), then press (OK).
If the icon is not visible, then the wizard is not available as the
transceiver has been programmed already with a non-basic
profile.
1 Press (Yes) to confirm that you want to start the wizard.
If you want to bypass the wizard, press (No).
Selecting a language
NOTE: This step in the wizard is shown if you have multiple
languages available.
To select a language:
1 Press or to scroll to the language that you want to use on
the control point, then press OK.
NOTE: The label above the key appears in the
selected language.
1 Press (Save) to save the information.
Setting the time and date
To set the time and date:
1 Press or to select the time zone that you want to use.
1 Press to move to the Daylight Saving entry.
1 Press or to select the time that you want to use.
1 Press to move to the Local Time entry.
1 Press to enter edit mode for the local time.
1 Press or to scroll to the value that you want to set, then
press to move to the next item.
1 Repeat this for minutes, seconds and AM/PM values.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English