USING THE WIZARD
USING THE WIZARD
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 29
Selecting an antenna
Each type of antenna has a specific requirement for tuning, and the
transceiver uses a different protocol for each one. You must select the
type of antenna that is used in your station so that the transceiver knows
how to tune the antenna. Some antennas, such as broadband antennas,
do not require tuning.
To select an antenna:
1 Press or to scroll to the antenna type that you want to use,
then press OK.
1 Press (Save) to save the information.
1 Do one of the following:
• If you want to connect an accessory to the 15-way
connector of the RFU, press (Yes), then continue
from
Selecting a peripheral device on page 30.
• If you do not want to connect an accessory, press
(No), then press OK to close the wizard.
To Next Page
Loading...
Need help?
General
