Codan Envoy Control Getting Started Guide

USING THE WIZARD
USING THE WIZARD
28 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Adding a Phone call
To continue with adding a Phone call:
1 Press to move to the Phone Number entry.
1 Enter the phone number.
1 Continue from Completing the contact on page 28.
Completing the contact
To finish entering the information required for the contact:
1 Press to move to the Call Description entry.
The call type is entered automatically as the call description.
1 Enter a new description for this call, if required.
1 Press (Save) to save the information.
1 If you want to add another call for the contact, press (Yes),
then repeat the steps for adding a call.
If you do not want to add another call, press (No).
1 If you want to add another contact, press (Yes), then repeat
the steps for adding a contact.
If you do not want to add another contact, press (No).
1 Do one of the following:
• If you want to select an antenna, continue from
Selecting
an antenna on page 29
.
• If you do not want to select an antenna, press
(Close), then continue from Selecting a peripheral
device on page 30.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English