OPERATING THE TRANSCEIVER
CALLING
56 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
1 If prompted, press or to scroll to the channel that you want
to use, then press CALL.
A is shown next to the currently selected channel/mode.
To abort the call before it is answered, press PTT or SCAN.
There will be audible beeps or a pop-up message to indicate that
the call has been successful.
NOTE: If Settings > Calling > General > LBT Mode
is set to Enabled or Override allowed, you
may be asked to make the call again if the channel
is occupied.
Making a Message call
If you want to send a text message to another station, make a Message
call.
You can:
• enter a message at the time that you make a call
• store up to 10 messages in User Data > Messages for later
use
• store messages in a contact as part of a pre-programmed
Message call
To make a Message call:
1 Press CALL.
NOTE: You may be prompted to register a self address on
this control point for the HF network that you are
using to make the call.
The call type and address of the last call are shown at the top of
the call screen. The filtered Call Log below this shows the latest
instance of any call type made to or received from a particular
address.
To Next Page
Loading...
Need help?
General
