OPERATING THE TRANSCEIVER
THE CHANNEL SCREEN
34 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Figure 6: Channel screen
NOTE: If you cannot transmit on the channel, Inhibit is shown
as the Tx frequency.
If the transmit and receive frequencies are the same, the frequency is
only shown on the right side of the screen. The Rx/Tx indicator shows
whether the transceiver is receiving (green) or transmitting (red). The
more bars that are shown, the higher the signal strength.
The status area of the screen provides six separate areas in which you
can show information that is relevant for your operations. Your system
administrator can choose the information that is shown in each status
area. If encryptor/scrambler options are enabled, this information is
shown in the top line of the status area (status areas 1 and 2). Any
selections that have been made are discarded.
NOTE: For information on how to set up what is shown in the
status areas, please see the Reference Manual.
channel name
Tx/Rx frequency
status areas
menu bar
status bar
mode
mute type
indicator
(highlighted
when mute is on)
call type
icon
Tx power
setting
signal
strength
indicator
Rx/Tx
indicator
left software key
right software key
volume indicator
missed call icon
To Next Page
Loading...
Need help?
General
