Codan Envoy Control Getting Started Guide

USING THE WIZARD
USING THE WIZARD
24 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
NOTE: The wizard automatically allocates this self
address to the default HF networks: Selcall and
CALM (if FED-STD-1045 ALE or
MIL-STD-188-141B ALE option is installed).
1 Do one of the following:
• If you want to add a contact, press (Yes), then
continue from
Adding a contact on page 24.
• If you do not want to add a contact, press (No), then
continue from Selecting an antenna on page 29.
Adding a contact
A contact is a person or organisation that you want to call, and for which
you want to pre-define the method of calling. You may be able to
contact the same person or organisation via a number of different
methods. When you set up the contact, you define each method as a
separate call for the contact.
To add a contact:
1 Enter the name that you want to use for the contact, then
press (Add Call).
The HF Network entry is highlighted.
The HF network defines the call system and self address that is
used by your station when the call is made.
1 Press or to select the HF network that you want to use.
1 Press to move to the Call Type entry.
1 Press or to select the call type that you want to use.
NOTE: The call type that you select affects information
that you can enter for the remainder of this call.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English