OPERATING THE TRANSCEIVER
CALLING
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 51
1 Press or to scroll to the call that you want to make.
The call types that are available for the contact are set up in User
Data > Contacts.
NOTE: If only one call has been set up for the contact, you
cannot change this at the time of the call.
1 Press CALL.
NOTE: Depending upon the call type and other
information stored with the contact, you may be
prompted to select information during the call.
Press CALL to progress through these prompts.
1 If prompted, press or to scroll to the channel that you want
to use, then press CALL.
A is shown next to the currently selected channel/mode.
To abort the call before it is answered, press PTT or SCAN.
There will be audible beeps or a pop-up message to indicate that
the call has been successful.
NOTE: If Settings > Calling > General > LBT Mode
is set to Enabled or Override allowed, you
may be asked to make the call again if the channel
is occupied.
Making a call from the Call History
The Envoy Transceiver stores information for up to 200 calls that have
been sent and received for a control point. Each control point may store
this call information for up to 20 RFUs to which it has been connected.
The detailed Call History is accessed by holding CALL, then
pressing to scroll to the Call History tab.
NOTE: For more information on the Call History, please see the
Reference Manual.
NOTE: The default behaviour for the CALL key is to press it to
start a call, or hold CALL to see your Contacts/Call
History. This behaviour may be reversed by your system
administrator, if required.
To Next Page
Loading...
Need help?
General
