COMPLIANCE
FCC COMPLIANCE
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 179
FCC compliance
FCC Part 90 certification
The Envoy Transceiver has been tested and certified to FCC Part 90
(FCC identifier code DYY2210).
FCC Part 15 compliance
Any modifications made to the Envoy Transceiver and 3020
Transceiver Supply that are not approved by the party responsible for
compliance may void your equipment’s compliance under Part 15 of
the FCC rules.
The Envoy Transceiver and 3020 Transceiver Supply have been tested
and found to comply with the limits for a Class B device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by switching
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and receiver
• connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
• consult the dealer or an experienced radio/TV technician for help
To Next Page
Loading...
Need help?
General
