Codan Envoy Control Getting Started Guide

USING THE WIZARD
USING THE WIZARD
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 23
1 Do one of the following:
• If you want to scan all of the channels in the transceiver
that have a USB mode, press (Yes), then continue
from
Entering a self address on page 23.
• If you want to choose the channels and modes that you
want to scan, press (No), then continue from
Adding channels to a scan table on page 23.
Adding channels to a scan table
To add channels to a scan table:
1 Press or to scroll to the channel that you want to add, then
press OK.
1 Press or to select the mode that you want to use.
1 Select more channels, as required.
1 Press (Save) to add these channel selections.
1 Continue from Entering a self address on page 23.
Entering a self address
A self address is used by other stations to call your station. For example,
if the self address of your station is 1234, operators at other stations
enter the address 1234 when they want to make a call to you.
To enter a self address:
1 Enter the address that you want to use.
You can enter up to six digits, or you may leave the self address
blank if a peripheral device has its own self address set.
NOTE: Addresses ending in one or more 9 or 0 digits have
a special function in Selcall HF networks.
1 Press (Save) to save the information.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English