Codan Envoy Control Getting Started Guide

USING THE WIZARD
USING THE WIZARD
22 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
1 Enter the receive frequency (in kHz, with up to three decimal
points or 1 Hz resolution), if required to be different from the Tx
frequency.
1 Press to move to the Mode entry.
1 To select a mode:
• Press to view the list of available modes.
• Press or to scroll to the mode that you want to use,
then press OK.
When the check box is selected, the item is enabled.
When the check box is clear, the item is disabled.
• Select other modes, as required.
NOTE: The modes that you select become the
allowed modes for this channel. In a scan
table, you can duplicate a channel and
select another of the allowed modes.
•Press (Save).
1 If you want to review the information that you have entered,
press or to move through the entries.
1 Press (Save) to save the information.
1 Do one of the following:
• If you want to add another channel, press (Yes),
then repeat these steps.
• If you do not want to add another channel, press
(No).
The channels that you enter may be allocated to a scan table. A
scan table enables you to manage how these channels are
scanned using one set of properties.
1 Do one of the following:
• If you want to add a scan table, press (Yes).
• If you do not want to add a scan table, press (No),
then continue from
Entering a self address on page 23.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English