USING THE WIZARD
USING THE WIZARD
18 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Using the wizard
The wizard should start automatically when a new transceiver is
powered up for the first time.
Figure 5: Wizard Startup screen
NOTE: If the wizard screen doesn’t launch automatically, follow
the instructions below. If your transceiver has been
profiled using the TPS System Programmer, the wizard
may not be available.
NOTE: For information on specific entries in the wizard, please
see the Reference Manual.
To use the wizard:
1 Press PTT, then press (Menu) to return to the top level of
the menu structure.
To Next Page
Loading...
