OPERATING THE TRANSCEIVER
MUTING THE TRANSCEIVER
44 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Muting the transceiver
When the transceiver is set to a channel or is scanning channels, and
mute is switched off, you hear on-air signals on each channel. If you do
not want to listen to this, you can silence the transceiver by switching
on mute.
You can set the mute to switch off when a voice signal or any other
calling activity is detected (voice mute V), or only when a call addressed
to your station is received (selcall mute S). Your choice of voice or
selcall mute depends on whether or not you have to detect voice signals,
and how much noise and traffic you want to hear. When digital voice is
active and scanning is switched off or paused, you can also set the mute
to switch off only when a secure or clear digital voice signal is detected
(digital voice mute D). The voice signal is output to the speaker
connected to the RFU or desk console speaker.
Switching mute on or off
To switch mute on or off:
1 If you are using a 2220 Handset or 2230 Desk Console,
press (Mute) on the channel screen, scanning screen, or
free-tune screen.
1 If you are using a 2221 Handset:
•Press (Options).
• Press or to scroll to the Mute On|Off option.
•Press (Select).
The V or S in the status bar of the channel screen is highlighted
when mute is on.
To Next Page
Loading...
Need help?
General
