COMPLIANCE
EMC AND SAFETY NOTICES
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 177
EMC
CAUTION: If it is necessary to remove the covers at any stage, they
must be refitted correctly before using the equipment.
To ensure that compliance with the EMC Directive is maintained.
1 Use standard shielded cables supplied from Codan (where
applicable).
1 Ensure the covers for the equipment are fitted correctly.
Electrical safety
To ensure compliance with the European Low Voltage Directive is
maintained, you must install and use the Envoy Transceiver in
accordance with the instructions in the Envoy Transceiver Getting
Started Guide and the Envoy Transceiver Reference Manual.
When using equipment that is connected directly to the AC mains these
precautions must be followed and checked before applying an AC
mains supply to the unit.
To ensure electrical safety:
1 Use the standard AC mains cable supplied.
1 Ensure the covers for the equipment are fitted correctly.
CAUTION: If it is necessary for a qualified electronics technician to
remove the covers during servicing, they must be refitted
correctly before using the equipment.
WARNING: A protective earth connection must be included in the
mains wiring to the 3020 Transceiver Supply.
WARNING: The protective cover must always be fitted when the 3020
Transceiver Supply is connected to the AC mains.
To Next Page
Loading...
Need help?
General
