Codan Envoy Control Getting Started Guide

USING THE WIZARD
USING THE WIZARD
30 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Selecting a peripheral device
When you select the peripheral device from the list, the transceiver
automatically sets these properties. The default settings should be
adequate for most situations, however, if you have special
requirements, please see the Reference Manual for more detailed
information.
NOTE: Codan peripheral devices are listed by their type number,
for example, 3031 Crosspatch. The type number for a
Codan device is located on the front or serial number
escutcheon.
To select a peripheral device:
1 Press or to scroll to the type of peripheral device that is
attached to the connector, then press OK.
If there are settings that you can change to customise this
peripheral for your requirements, is shown to the right of the
peripheral name when it is selected.
1 If you want to change settings for the peripheral, press to see
the list of entries that you may change.
If the value of an entry for a peripheral device has been changed
from the default value, is shown next to the title of the entry.
1 Press (Save) to automatically update settings for correct
operation of the connected peripheral device.
1 Press OK to close the wizard.
1 If you added a peripheral device, restart your transceiver to
activate the new settings.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English