Codan Envoy - Page 136

CONTACTS
ADDING A CONTACT
124 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
1 To select a channel:
• Press to view the list of available channels.
• Press or to scroll to the channel that you want to
use, then press OK.
A is shown next to the channel/mode.
• Press or to change the mode, if required.
NOTE: If you are not able to select a different
mode, then only one mode is allowed for
this channel. If you want to use a different
mode, go to the relevant scan table,
duplicate the channel, then select the new
mode for this channel.
•Press (Save).
1 If you want to add another call, press (Options), scroll to
Add Call, press (Select), then repeat the steps for adding
a call.
1 Press (Options), scroll to Save, then press
(Select).
1 Press (Close).