INSTALLING THE TRANSCEIVER
OVERVIEW OF MOBILE STATIONS
158 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Mounting the speaker
To mount the speaker:
1 Secure the mounting cradle to the surface with at least two
screws.
Ensure there is sufficient space at the rear for the cable.
1 Attach the speaker to the cradle with the two screws and rubber
washers.
Mounting the handset and speaker connector
To mount the handset and speaker connector:
1 Use cable ties or screws to secure the handset and speaker
connector in a suitable location.
Mounting the RFU
CAUTION: If you are transferring a fixed station to a mobile station
and you have attached rubber feet to the bottom of the
RFU, you must remove the rubber feet before installing it
into the mounting cradle.
To mount the RFU:
1 Secure the mounting cradle to the surface with at least four
screws, one in each corner of the cradle.
NOTE: Ensure there is sufficient space at the rear of the
cradle to clear the RFU heatsink.
1 If the key is locked to the base of the cradle, flip the key away
from the base until it can be rotated (see
Figure 46), then rotate
the key in a counterclockwise direction.
To Next Page
Loading...
Need help?
General
