Codec Tieline Gateway

To Next Page

To Previous Page

141

Gateway and Gateway 4 Manual v1.2

Important Notes:

· SmartStream PLUS redundant streaming over multiple IP interfaces mitigates lost

packets and provides IP network backup if an IP link is lost.

· Only one SmartStream PLUS connection per audio stream is supported with

uncompressed PCM, or when encoding with aptX Enhanced, G.711 or G.722

algorithms.

· Two SmartStream PLUS connections are supported per audio stream with Music PLUS

encoding.

· Up to three SmartStream PLUS connections are supported per audio stream when

encoding using Tieline Music, AAC algorithms, MP2, MP3 and Opus.

· TieLink only supports one SmartStream PLUS redundant connection for each audio

stream. TieLink also does not support uncompressed PCM connections, or encoding

using aptX Enhanced, G.711 or G.722.

8. Click the drop-down Failure Mode arrow and select Automatic reconnect to enable this

feature and configure Failure Parameters. To add another stream endpoint select the check-

box for Create another dialing connection, then click Next.

9. Name the connection and then click Next.

10. Enter destination settings for the dialing connection, then click Next.

11. There are four options at this point:

· Click Add a SmartStream PLUS connection to add a redundant stream for the current

connection.

· Select Create another dialing connection to create another stream endpoint.

Codec Tieline Gateway - Page 141