Codec Tieline Gateway - Page 231

231
© Tieline Research Pty. Ltd. 2021
Gateway and Gateway 4 Manual v1.2
To adjust this setting:
1. Press the SETTINGS button.
2. Select Transports and press the button.
3. Use the down navigation button to select LAN1, LAN2 or a VLAN interface.
4. Select Configuration and then IPv6 Mode and press the button.
5. Select Auto, Manual or Off and press the button.
6. Press the Return button, then select Save in the confirmation dialog and press the
button to confirm the new settings.
By default the codec is configured to allow the codec to automatically receive IPv6 address
information from an IPv6 enabled router.
Manual IPv6 Address Assignment
Select Manual mode using the previous procedure and enter information into the IPv6 Address,
IPv6 Prefix Size and IPv6 Gateway fields in the codec to manually configure address details.
DNS Server
It is possible to specify Domain Name Server (DNS) settings to allow easy look up of codecs within
the specified DNS Addresses or Domains section within the Web-GUI. This feature can be turned
on or off in the LAN codec menu.
1. Press the SETTINGS button.
2. Select Transports and press the button.
3. Use the down navigation button to select LAN1, LAN2 or a VLAN interface, then press
the button.
4. Select Configuration and press the button.
5. Use the down navigation button to scroll to Set DNS.
6. Press the button to toggle between Auto and Manual.
7. Enter DNS Address and Domain details as required.
8. Press the Return button, then select Save in the confirmation dialog and press the
button to confirm the new settings.
Link Mode Configuration
It is possible to configure the Ethernet link speed (10/100/1000/Auto) and whether each interface will
operate in Full-Duplex or Half-Duplex modes.
1. Press the SETTINGS button.
2. Select Transports and press the button.
3. Use the down navigation button to select LAN1, LAN2 or a VLAN interface, then press
the button.
4. Select Configuration and press the button.
5. Use the down navigation button to scroll to Link Mode.
6. Press the button to select a preferred setting. Note: Default setting is Auto.
7. Press the Return button, then select Save in the confirmation dialog and press the
button to confirm the new settings.