INS_CNGE3FE8MS[POE][HO] Rev. 11.7.17 PAGE 111
INSTRUCTION MANUAL CNGE3FE8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Object Description
Power Source For being able to determine the amount of power the PD may use, it must be defined what
amount of power a power source can deliver.
Valid values are in the range 0 to 360 Watts (depending on model).
Port Configuration
Port This is the logical port number for this row. Ports that are not PoE-capable are grayed out or not
listed and thus impossible to configure PoE for.
PoE Mode
Disable PoE disabled for the port.
PoE Enables IEEE 802.3af PoE protocol for maximum 15.4W per port.
PoE+ Enables IEEE 802.3at PoE protocol for maximum 30W per port.
PoE++ Enables 60W PoE per port (HO models only).
Forced Enables 60W PoE Force mode per port (HO models only).
Priority The priority is used in the case where the remote devices require more power than the power
supply can deliver. In this case the port with the lowest priority will be turned off starting from
the port with the highest port number.
Low The lowest priority
High The medium priority
Critical The highest priority
Maximum Power The Maximum Power value contains a numerical value that indicates the maximum power in
watts that can be delivered to a remote device.
The maximum power for each port is 30 W or 60 W depending on model and port number.
Apply Click to apply changes.
Reset Click to revert to previous values.
Warning – Please use the Forced mode feature with caution and ensure it’s only enabled when
a 60 W PoE device is attached. It should only be enabled if the 60 W devices fail to
power up without this option enabled.
To Next Page
Loading...
