INS_CNGE3FE8MS[POE][HO] Rev. 11.7.17 PAGE 42
INSTRUCTION MANUAL CNGE3FE8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Access Management
Configure access management table on this page. The maximum number of entries is 16. If the
application’s type matches any one of the access management entries, it will allow access to the
switch.
Object Description
Mode Indicates the access management mode operation. Possible modes are: Enabled: Enable access
management mode operation.
Disabled: Disable access management mode operation.
Delete Check to delete the entry. It will be deleted during the next save.
VLAN ID Indicates the VLAN ID for the access management entry.
Start IP address Indicates the start IP address for the access management entry.
End IP address Indicates the end IP address for the access management entry.
HTTP/HTTPS Indicates that the host can access the switch from HTTP/HTTPS interface if the host IP address
matches the IP address range provided in the entry.
SNMP Indicates that the host can access the switch from SNMP interface if the host IP address matches
the IP address range provided in the entry.
TELNET/SSH Indicates that the host can access the switch from TELNET/SSH interface if the host IP address
matches the IP address range provided in the entry.
Apply Click to apply changes.
Reset Click to revert to previous values.
Add New Entry Click to add a new access management entry.
To Next Page
Loading...
