INS_CNGE3FE8MS[POE][HO] Rev. 11.7.17 PAGE 284
INSTRUCTION MANUAL CNGE3FE8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Listing All Show Commands
The following example raises the session privilege level to 15. In this example, an enable secret
has been specified, so password entry is required to proceed. Then the user inputs show and uses
the context-sensitive help feature to list the possible show commands, in this case for a Carrier
Ethernet system.
my-device> enable Password: ***
my-device# show ?
aaa Login methods
access Access management
access-list Access list
aggregation Aggregation port configuration
clock Configure time-of-day clock
dot1x IEEE Standard for port-based Network Access Control
eps Ethernet Protection Switching
erps Ethernet Ring Protection Switching
evc Ethernet Virtual Connections
green-ethernet Green ethernet (Power reduction)
history Display the session command history
interface Interface status and configuration
ip Internet Protocol
ipmc IPv4/IPv6 multicast configuration
ipv6 IPv6 configuration commands
lacp LACP configuration/status
line TTY line information
link-oam Link OAM configuration
lldp Display LLDP neighbors information.
logging Syslog
loop-protect Loop protection configuration
mac Mac Address Table information
To Next Page
Loading...
