INS_CNGE3FE8MS[POE][HO] Rev. 11.7.17 PAGE 23
INSTRUCTION MANUAL CNGE3FE8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
System Log
Configure System Log on this page.
Object Description
Server Mode Indicates the server mode operation. When the mode operation is enabled, the syslog message
will send out to syslog server. The syslog protocol is based on UDP communication and received
on UDP port 514 and the syslog server will not send acknowledgments back sender since UDP is a
connectionless protocol and it does not provide acknowledgments. The syslog packet will always
send out even if the syslog server does not exist. Possible modes are:
Enabled: Enable server mode operation.
Disabled: Disable server mode operation.
Server Address Indicates the IPv4 host address of syslog server. If the switch provide DNS feature, it also can be a
host name.
Syslog Level Indicates what kind of messages will sent to the syslog server. Possible modes are:
Error: Send the specific messages which severity code is less or equal than Error(3).
Warning: Send the specific messages which severity code is less or equal than Warning(4).
Notice: Send the specific messages which severity code is less or equal than Notice(5).
Informational: Send the specific messages which severity code is less or equal than
Informational(6).
Apply Click to apply changes.
Revert Click to revert to previous values.
To Next Page
Loading...
