Comnet CNGE3FE8MSPOE - Page 268

INS_CNGE3FE8MS[POE][HO] Rev. 11.7.17 PAGE 268
INSTRUCTION MANUAL CNGE3FE8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Table 6 - Modes
Mode Parent Mode Description
Exec Lowest-privileged mode; used for basic system monitoring. Generally does
not allow modifications to the system
Command: disable
Prompt: hostname>
Privileged Exec Exec Privileged mode; allows configuration and other modifications to the system
Command: enable
Prompt: hostname#
Config Priv.Exec Global configuration mode
Command: configure terminal Prompt: hostname(config)#
VLAN Config Config Sub-mode for configuring active VLANs
Command: vlan vlan_id_list
Prompt: hostname(config-vlan)#
VLAN Interface
Config
Config Sub-mode for configuring VLAN interfaces
Command: interface vlan vlan_id_list
Prompt: hostname(config-if-vlan)#
Interface Config Config Sub-mode for configuring Ethernet interfaces
Command: interface type switch_num/port_num
Prompt: hostname(config-if)#
Line Config Sub-mode for configuring terminal lines
Command: line { con | vty } line_num
Prompt: hostname(config-line)#
IPMC Profile Config Config Sub-mode for configuring IP Multicast profiles
Command: ipmc profile profile_name
Prompt: hostname(config-ipmc-profile)#
SNMP Server Host
Config
Config Sub-mode for configuring SNMP server host entries
Command: snmp-server host host_name
Prompt: hostname(config-snmps-host)#
STP Aggregation
Config
Config Sub-mode for configuring Spanning Tree Protocol aggregation
Command: spanning-tree aggregation
Prompt: hostname(config-stp-aggr)#
DHCP Pool Config Config Sub-mode for configuring DHCP client pools
Command: ip dhcp pool pool_name
Prompt: hostname(config-dhcp-pool)#
RFC2544 Profile
Config
Config Sub-mode for configuring RFC2544 profiles
Command: rfc2544 profile profile_name
Prompt: hostname(config-rfc2544-profile)#
Y.1564 Config Config Sub-mode for configuring Y.1564 profiles
Command: y1564 profile profile_name
Prompt: hostname(config-y1564-profile)#
JSON Notification
Host Config
Config Sub-mode for configuring JSON notification hosts
Command: json notification host host_name
Prompt: hostname(config-json-notif-host)#
It is possible for a user to transition between these modes using certain commands, subject to the
user’s privilege level and the current session privilege level (see Understanding Privilege Levels,