INS_CNGE3FE8MS[POE][HO] Rev. 11.7.17 PAGE 84
INSTRUCTION MANUAL CNGE3FE8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
TACACS+
This page allows you to configure the TACACS+ servers.
Object Description
Global Configuration
Timeout Timeout is the number of seconds, in the range 1 to 1000, to wait for a reply from a
TACACS+ server before it is considered to be dead.
Deadtime Deadtime, which can be set to a number between 0 to 1440 minutes, is the period during
which the switch will not send new requests to a server that has failed to respond to a
previous request. This will stop the switch from continually trying to contact a server that it
has already determined as dead.
Setting the Deadtime to a value greater than 0 (zero) will enable this feature, but only if more
than one server has been configured.
Key The secret key - up to 63 characters long - shared between the TACACS+ server and the
switch.
Server Configuration
Delete To delete a TACACS+ server entry, check this box. The entry will be deleted during the next
Save.
Hostname The IP address or hostname of the TACACS+ server.
Port The TCP port to use on the TACACS+ server for authentication.
Timeout This optional setting overrides the global timeout value. Leaving it blank will use the global
timeout value.
Key This optional setting overrides the global key. Leaving it blank will use the global key.
Apply Click to apply changes.
Reset Click to revert to previous values.
Delete Click to undo the addition of the new server.
Add New Server Click to add a new TACACS+ server, up to 5 servers supported.
To Next Page
Loading...
