3033-010B Section 10: Vending
Concordia Xpress Technical Support Manual 10-3
2900-300B
Installing a Vending Unit
Installation of vending units is done by Concordia, prior to a customer
receiving the machine. Existing units cannot be upgraded in the field by a
technician. If a customer wishes to add vending to an existing machine,
please contact Concordia Beverage Systems for assistance at 1-800-
778-0990.
Removing a Vending Unit
1. Follow steps 1 through 6 of the Replacing a Card Reader
instructions on page 10-2.
2. Replace the door assembly handle with a non-vending handle.
3. Remove the vending backpack
a. Remove the back panel of the machine.
b. Remove the left panel of the machine.
c. Disconnect the harness wiring connecting the backpack
to the left side bracket
4. Re-attach the left panel of the machine.
5. Re-attach the back panel of the machine.
6. Re-attach the right door assembly.
7. Navigate to SPECIAL FEATURES > VENDING and ensure the
vending option is disabled.
Troubleshooting
If a vending unit is not functioning as expected, first try rebooting the
power to the machine.
If a vending unit is installed but does not appear to be working, navigate
to SPECIAL FEATURES > VENDING and ensure the vending option is
enabled.
For further assistance troubleshooting issues with the vending unit, see
the vending system troubleshooting trees in Section 15: Troubleshooting.
To Next Page
Loading...