ConMed Advantage - Page 107

99
SHAVER
HANDPIECES
D
3.9.2.2 Using the Handpiece Direction
Select and ON/OFF Buttons to
Change Speed
NOTE: This process applies ONLY to the
APEX Full-Function (C9828) and APEX
(C9824) and Advantage (D9824/D9924)
2-Button Handpieces.
1. The “Direction” and “On/Off”
button function can be changed to
“Increase Speed” and “Decrease
Speed” respectively. To change the
button functionality:
(a) Stop the handpiece. Press and
hold the Direction Select
Button to enter the speed
menu. An audible beep will sound
twice indicating that the handpiece
button function has changed. Release
the button. To increase the speed, press
this button again until the desired speed
is obtained.
(b) To decrease the speed, press the
handpiece On/Off button.
(c) When no further speed change is
requested, the audible beep will sound
twice again indicating that the button
functionality has returned to “Direction”
and “On/Off” control.
3.9.2.3 Using the Handpiece Speed
Buttons to Change Speed
NOTE: This process applies ONLY to the
APEX (C9828) and MicroChoice (MC9828)
Full-Function Handpieces.
1. Press the handpiece Increase button to
increase the handpiece speed. The
speed will change incrementally. When
the button is pressed and held, the speed
will change continuously
2. Press the handpiece Decrease button to
decrease the handpiece speed. The
speed will change incrementally.
When the button is pressed and held, the
speed will change continuously.