ConMed Advantage - Microchoice Saws; Reciprocating Saw (5020-023) Operation

82
MICROCHOICE
HANDPIECES
C
3.5 MicroChoice Saws
3.5.1 Reciprocating Saw (5020-023)
Operation
NOTE: Use only Hall 5053 series flat or
round shanked blades.
1. To insert a blade:
(a) Place the “SAFE/RUN” Slide in the
“SAFE” position.
(b) Twist the blade lock collar counter-
clockwise and insert the shank of the
blade into the collet. Ensure the blade
is fully seated.
(c) Twist the blade lock collar clockwise
and tighten securely.
2. Round shank blades can be seated at any
position within a 360° range.
3. Verify the blade is securely tightened by
briefly activating the handpiece. To activate
the handpiece:
(a) Place the “SAFE/RUN” Slide in the
“RUN” position. The controller will
display the handpiece I.D. and its
maximum (default) rpm or speed
setting. If being used in Port 2 of the
Advantage controller, and irrigation is
being used, the top display will also
show the set flow rate (“OFF” will be
displayed if irrigation is not used).