89
MICROCHOICE
HANDPIECES
C
3.6.2 Pin and Wiredriver Attachments
Insertion of pins and wires, and the functionality
of the handpiece with either pins or wires, is the
same with either attachment.
3.6.2.1 Wiredriver Attachment
(5020-028)
The Wiredriver attachment cannulation accepts
threaded or unthreaded K-Wires from 0.028 in.
to 0.062 in. (0.7 mm to 1.6 mm).
3.6.2.2 Pin Driver Attachment
(5020-032)
The pin driver attachment cannulation accepts
Steinman Pins from 0.079 in. to 0.125 in
(2.0 mm to 3.2 mm).
3.6.2.3 Pin and Wire Insertion
1. To insert a pin or wire:
(a) Push the Advancement Lever forward,
or away from the handpiece.
(b) Insert the wire or pin, either from the
front or rear of the handpiece.
2. To operate the handpiece:
(a) Grip the wire or pin by squeezing the
Advancement Lever.
To Next Page
Loading...
